17% (70)
•
228 views
•
3 pages
JUSP-NS600 and SGDH Parameter Initialization via CN7 (W-Protocol)
AI-enhanced description
This document describes how to reset all JUSP-NS600 Indexer and SGDH- servo amplifier parameters to factory settings via port CN7 using W-protocol, useful when serial communications via port CN6 are locked out due to an invalid Pn800 setting. It provides step-by-step commands for initialization, software reset, and verification, along with additional instructions for checking and changing serial communication protocol and baud rate parameters.
Uploaded by
Giulia_XYZ
Loading document…
Failed to load PDF
Download insteadYou might also like
PDF
36% (28)
VARISPEED-676H5 Inverter Technical Manual
98 pages
PDF
85% (97)
PLCs and Robots: The Quest for a Single Controller
10 pages
PDF
14% (18)
MPiec Controller Firmware Release Notes
4 pages
PDF
3% (61)
Yaskawa V7 Remote Digital Operator Kit Installation Guide
3 pages
PDF
71% (64)
PLCopen Function Blocks for Yaskawa MPiec Controllers Application Note
31 pages
PDF
73% (81)
GA800 IP55/UL Type 12 External Heatsink Drive Quick Setup Guide
4 pages
PDF
66% (33)
MOTIONPACK-SG1 Single-Axis Motion Controller Safety and Operational Manual
65 pages
PDF
19% (95)
Yaskawa Σ-V-SD Series AC Servo Drives Design and Maintenance Manual
364 pages
PDF
99% (5)
SGDV Series Servo Drive Outline Drawing
1 pages
PDF
46% (68)
SigmaLogic Software Package Release Notes
2 pages
Sponsored
