83% (98)
•
1.9k views
•
9 pages
PNQ22.0 Profinet Slave to 800xA Configuration Guide
AI-enhanced description
This document explains how to connect and configure a Profinet slave (specifically a PNQ22.0 with UMC motor controllers) to the 800xA system using Control Builder M. It covers adding the slave to the Profinet network, configuring station name, IP address, and FBP-addresses, as well as reading ABB-specific diagnostic data (Sequence of Event) from intelligent slaves like the UMC.
Uploaded by
zoé.599
Loading document…
Failed to load PDF
Download insteadYou might also like
PDF
41% (26)
ABB Mylos KNX 2 Binary Inputs 1 Switch Rocker Datasheet and Installation Guide
2 pages
PDF
99% (11)
Quickfit Nexus Pro LED Exit and Emergency Luminaire Installation Manual
4 pages
PDF
22% (88)
ZTS(D) Automatic Transfer Switch Enclosure Engineering Drawing
5 pages
PDF
72% (54)
ICOS GLA431-MCIA Benchtop Continuous Flow Analyzer User Manual
111 pages
PDF
70% (89)
ABB-Welcome IP Door Entry System Catalog
54 pages
PDF
60% (1)
ABB Emergency Lighting Luminaire Instruction Leaflet
2 pages
PDF
11% (29)
CM-MPN.x2 Three-Phase Monitoring Relay Data Sheet
16 pages
PDF
73% (17)
ABB Collaborative Robot Portfolio Selection Guide
8 pages
PDF
13% (14)
ABB i-bus EIB 1-10V Dimming Actuator Operating Instructions
11 pages
PDF
14% (54)
ABB Ability SSC600 Smart Substation Control and Protection Product Guide
48 pages
Sponsored
